+44 (0)1744 886660
sales@actmeters.com
40% Discount
ACT Luminaire Battery Tester
Whilst stock lasts, customers can purchase ACT Luminaires at £94.20 each - 40% off the usual list price of £157.00.
- Tests 2.4V (2CELL) and 3.6V (3CELL) 'Type C' Nickel Cadmium batteries used in stand-alone emergecy light luminaires
- Takes minutes to perform a 1 hour AND full battery duration test as required by BS5266
- Identifies defective batteries in seconds
- Leaves sufficient capacity after a full battery duration test to power the emergency light for at least 30 minutes
- Simple in operation – no buttons or complicated settings
- Automatically detects which battery voltage type is fitted
- Allows ALL emergency lighting luminaires to be tested during one service visit
50% DISCOUNT
ACT 5000 Autoranging Multimeter
The ACT 5000 autoranging multimeter includes a 50,000 count digital display which enables resistance measurements to be measured down to one-hundredth-of-one-ohm. A unique feature is its switchable 5Amp/20Amp AC/DC current range which enables current measurements from 10uA to 20Amps to be read safely, without changing lead positions or blowing a fuse. The ACT 5000 is attractively styled in a rugged ABS case with flip stand and is supplied with test leads and operating manual.
- HOLD (holds the reading displayed)
- REL (enables circuits to be tested without seeing EOL resistors)
- MAX/MIN (enables variations in readings to be identified and recorded)
- RANGE (switches between auto/manual settings)
10% WEB Discount
ACT 2500 Manual Multimeter CAT II
Offering fantastic value for money, our new ACT 2500 provides the security industry with a much needed ‘budget’ manual multimeter capable of performing all the tests necessary for alarm installation and troubleshooting.
- Provides two essential AC ranges, 2V and 20V for identifying troublesome induced AC voltage as well as 200V and 750V for direct testing of AC supplies
- Five DC voltage ranges
- Six selectable resistance ranges to allow testing and troubleshooting of any ‘normally-closed’ and ‘end-of-line’ alarm circuits
- Continuity ‘beeper’ for audible resistance testing up to 50 Ohms
- Selectable AC/DC current ranges for measuring accurate supply currents to PIRs, LIMs and external sounders etc
- Extremely useful battery tester is included for load testing 1.5V and 9V batteries
- ‘Auto power off’ function to conserve battery power
- ‘Hold’ button freezes the measurement on display to enable readings to be recorded easily
- Large rotary switch for precise selection of 24 ranges within 6 functions
50% DISCOUNT
ACT Cable Caster
The ACT Cable Caster is a handheld dart gun device that allows cables to be threaded through hard-to-reach places such as suspended ceilings and lofts. The installer simply ties the monofilament line to the dart, stands up to 50 feet away from the cable supply and shoots. Once the cable is attached to the line it can be reeled in up and over any obstacles easily.
It is supplied with three aerodynamic, glow-in-the-dark darts. Each are highly accurate and may be cast up to 50 feet away.
50% DISCOUNT
ACT MultiStripper Cabling Tool
Our Multi-Stripper+ is an essential four-in-one tool for anyone carrying out electrical work. Robust, compact and fun to use, the Multi-Stripper+ combines a slot or cross head screwdriver, AC volt tester, cable cutter for wires and cables up to 9mm and a cable stripper for numerous cable types – including BT, alarm, mains (round &flat) and coaxial cables - up to 13mm. An ideal tool for saving time and space in your toolbox.
20% Discount
10 Minute Shunt Lock
Fitting security shunt locks is a time consuming and fiddly job. What typically takes hours to install can now be done in a fraction of the time with our 10 Minute Shunt Lock.
- Designed to fit security shunt locks quickly and above all, accurately
- Supplied with 950mm long bit, jigs and cutters
- 10mm x 950mm bit will drill 10mm hole accurately through the centre of a door
- Self-centring jig reduces marking-up time
- Vertical guide for height and depth ensure cut areas are not overrun
- Chisel shaped cutters designed for fitting a Chubb 3G114 shunt lock and faceplate
- Cutters will not clog nor deviate even if it hits a knot in the wood
- Tools are supplied in a robust case with safety goggles
- Fast, accurate and save you time and money
